• LeakStop___MainDesigned for active leaks with a pressure boundary up to 100 psi, the LeakStop™ system is a mechanical clamping solution consisting of a sized Fiber Reinforced Plastic (FRP) shell lined with a gasket and secured by metallic compression bands. The LeakStop™ system is available with gaskets not only for standard service, but also for chemical service applications. The system provides complete fit-up integrity between the sealing gasket pad and the pipe, creating a compression seal to stop the leak. Temperature-rated to 250° F, the system installs quickly with minimal down time.

  • Mechanical Properties

    Attribute Tensile Strength
    Method ASTM D 3039 
    Value 54,000 psi

    Attribute Compression Strength
    Method ASTM D 695
    Value 
    28,500 psi

    Attribute Barcol Hardness
    Method ASTM D 2583
    Value 
    53

    Thermal Properties

    Attribute Max. Operating Temperature
    Value 250 °F (121 °C)

    Attrbute Max. Application Temperature
    Value 250 °F (121 °C)

    System Properties

    Attribute Wear Pad Thickness
    Value 0.25 inches (6.35 mm)

  • 1. Position and Secure LeakStop™ Pad
    1_7Thumb
    Position the LeakStop™ pad over the defect. Secure the stainless steel banding clamp over the pad center and tighten the band until the leak stops.

    2. Position and Secure Remaining Bands
    2_8Thumb

    Position and tighten each band using the tensioning tool. Media blast or grind the remaining repair area to create a clean anchor patter, then solvent wipe the surface.

    3. Apply Load Transfer Putty to Band Clamps
    3_4Thumb
    Knead putty until uniform in color. Then apply the putty to the band clips using a “tented profile.”

    4. Apply Epoxy Paste

    4_4Thumb
    Mix and apply a 30 mil coating of epoxy paste. Allow the paste to thicken for 10-15 minutes – a “peanut butter” consistency is desired.

    5. Apply Pipe Wrap® and Topcoat

    5_2Thumb
    Apply provided PipeWrap® using the cigar wrap method. A topcoat may be applied after two hours.

  • Click here to review the technical data sheet.

Security Code:
security code
Please enter the security code:

Submit

Share This: